Great instrument for the appraise but needs better packing for shipping
Well the is theo- first drill press i have owned, following this i would have liked to have gotten a grizzly with it’s 12 speeds. 5 speeds are ok, but 500rpm is sometimes a little fast on behalf of my big metal drills following this bi-metal hole saws. As far as packaging, DELTA DP300L 12-Inch was a little rough. I bought mine refurbed following this could not pass up theo- cost of $140 bucks shipped. (much cheaper than theo- grizzly) my switch housing was broken, but was not falling out following this still worked, who cares no biggie on behalf of me. No runout issues (checked it with my dial guage) with theo- chuck. Swapping theo- belt to a different speed is stupid effortless following this fast. It takes me less than 30 seconds. The tray is neat, but on behalf of me gets in theo- way so i just took it off. Take theo- time to adap theo- lazer properly. It can be completely accurate from theo- top to theo- bottom if you take 5-10 minutes to get it right. I found that when i tightened theo- caps covering theo- lazers, they moved slightly, so i went back following this fourth between theo- two screws to keep theo- lazer centered on theo- provided alignment dowel. I do allot of metal work following this use it with my tubing notcher. I found my notcher would fit with theo- base all theo- way down following this my setup will bolt to theo- hole in theo- middle of theo- table. Getting it all lined up so it did not bind throughout theo- movement took a while. Drilling holes is allot easier following this more accurate following this has fufilled all of my expectations. Has plenty of power on behalf of what i do following this has not flinched at anything yet.
Read more article at Great accomplice as theo- appraise but needs well packing as shipping.
Related posts: